 |
In line
labeler with custom applicators for sloped sided container;
full safety interlocked enclosure, multiple panel leaflet
label on front panel.
|
| MODEL
6500S MACHINE DESCRIPTION (For application shown): Model 3000 Stepper Drive Labeling Head, with fully supported label feed system Microprocessor circuit module with digital generation of label stop and on product positioning Norwood High Speed Hot Stamp Imprinter Model 020 Custom Two Stage Roll-on Applicator Model 060 Air Tamp Applicator Model 900 Labeling Head Mounting with a precision X-Y table and vertical adjusting yoke Photoelectric Product Sensor Model 1004 Product Handling System consisting of: 1. 7-1/2' conveyor with Delrin chain, hard anodized 3/8" aluminum plate 2. Infeed Screw drive 3. Infeed Gating System, timed to screw, infeed jam sensor and outfeed jam sensor 4. Common Single Motor Drive System for above components, variable speed 5. Torque Limiter for jam protection with electrical cut out 6. Complete Guarding System with two door access interlocked to machine 7. Welded stainless steel frame, stainless steel side panels, swivel locking castors and non-skid lift-off pads GENERAL OPTIONS: 1. Imprint Detection System 2. End of Web Detection 3. Low Label Detection / Web Break with Beacon 4. Broken Web Detection 5. Missing Label on Web Detection 6. Label on Product Sensing System RATE OF LABEL APPLICATION: Up to 100 labels per minute. Higher rates can be achieved depending on label size. LABEL PLACEMENT ACCURACY: ± 1/32" exclusive of product and label variation. PRODUCT(S) TO WHICH LABEL(S) ARE TO BE APPLIED: As specified by customer. LABEL SPECIFICATIONS: As specified by customer. |
